Skip to content
Ahmad Ammar

7. Your own neighbourhood

7.1 Reading responsibly

Every number above rests on what volunteers have mapped. Before trusting a figure, ask:

  • Coverage: are all buildings mapped? Compare with satellite imagery for a few blocks. Are floors or heights tagged for most buildings, or are we assuming? (The table in the Buildings section reports this.)

  • Edges: a square study area cuts streets and blocks at its border; measures near the edge are biased.

  • Definitions: a 'walk' network includes footpaths that a 'drive' network lacks; dead ends for cars may be through routes on foot. Say which you used.

  • Population: OSM holds no population counts. Use a census or a gridded product (WorldPop, GHSL) for people per km².

  • The lived city: numbers say nothing of safety, shade, noise, cost, who is welcome. Walk it, talk to people, read its history. Use the numbers to sharpen questions, not to end them.

Questions to take to your own neighbourhood. Change PLACES in the first cell to your street and run everything. Is your area closer to a grid or to an organic pattern, and why (when was it built, by whom, over what)? Which street has the highest betweenness, and is that where the shops are? How many of the seven everyday kinds can you reach in 15 minutes, and which is missing? Which fabric type is your home in, and what would it take to change it?

7.2 The same measures in your browser

The Urban form explorer computes the measures of this guide for any area you choose, with no installation. It fetches OpenStreetMap data from the same public Overpass servers, works in a local metric projection in the browser, and reports streets (density, junctions, dead ends, circuity, route directness, orientation order with a rose diagram), buildings (count, footprints, floors where tagged, GSI, FSI, open space ratio), access (walking distance along streets to the nearest place of each everyday kind) and composite indices for walkability, cyclability and public transport, always shown with their parts. Each figure links to its formula on the methods page, and each analysis reports how much of the area carries the tags it relies on. Use the notebook to understand a measure, and the explorer to apply it widely; when the two disagree, the notebook shows you why.

7.3 What you have learned

  • Urban form has layers that change at different speeds: streets, plots, buildings.

  • OpenStreetMap stores the city as nodes, ways and tagged relations; OSMnx turns streets into a graph.

  • Network measures (intersection density, streets per node, dead ends, orientation order, circuity, route directness, betweenness) describe how a street pattern works for movement.

  • Building measures (GSI, FSI, floors, OSR, elongation, compactness, shared walls) describe grain and density.

  • Network distance, not straight-line distance, decides what you can reach.

  • Clustering many cells by their measures yields fabric types you then name and question.

  • Every figure depends on mapping completeness, which must be checked and reported.